OBS: Keep in mind that those commands will change your IP, but the new IP will still be tighed up to you. Ipconfig /renew (this will renew your iP) Ipconfig /release (this will release your IP) This command will give all that info but for all networks you might have it.Īlso, in case you have a dynamic IP and want to change it, then type…

This is good to know if someone is doing arp poisoning in your LAN.ĥ) route : This command will show you the routing table, gateway, interface and metric.Ħ) ipconfig : This command will show tons of very helpful things. Tracert (is the website you don’t know the IP)Ĥ) arp : This command will show you the arp table. OBS: This command is good to know the route a packet takes before it goes to the target box. In case you looking for “How to spoof email”, then look for my “How to spoof email tutorial” …p threadid=2360ģ) tracert : This command will give you the hops that a packet will travel to reach its final destination. To send spoofed mail to your friends or even for SE. OK, now why would you want to have an IP of a mail server? You can use whatever server you want and if it is listed on DNS, then you get the IP. This command will give you the mail server IP of. Now, another really nice function of nslookup is to find out IP of specific Mail Severs. Nslookup (is the website you want to find out the IP)

Lets say you know the website URL but you don’t know its IP(and you want to find out). OBS: Keep in mind that if the host you pinging is blocking ICMP packets, then the result will be host down.Ģ) nslookup : This command has many functionalities. Ping (is the website you want to ping, but you don’t know the IP) Read it and understand what the command does.ġ) ping : This command will allow you to know if the host you pinging is alive, which means if it is up at the time of executing the “ping” command. A little help will show up in your screen. In case you don’t know some of them, then just type the command on CMD and hit enter. In case you don’t know how to get CMD open in your box, then click on Start, then Run, then type “cmd” (no quotes, off course… you know the drill). We will have some fun with NetBIOS on CMD.įirst thing you need to know is some very helpfull commands to use on CMD(Command Prompt). This is just to make sure you have NetBIOS enabled. Now back to the main Local Area Connection window, select File and Print Sharing for Mic****ft Networks and hit enter. Then Select TCP/IP and click on Properties again. So i am Posting This….įirst, open your Network Connection and right click and select Properties. I am Sure u guys Know All these commands….

Cmd hacking over lan